For a leaky toilet water shut-off valve the easiest solution is to tighten the package nut 14 turn with a wrench. Toilet Water Supply Line Leak at the Fill Valve.
How To Adjust The Water Level In A Toilet Tank Toilet Fill Valve Toilet Tank Diy Plumbing
Clean the washers with a cloth.
How to fix a toilet water supply valve. The inlet nut holds the valve in place. Turn on the water supply and inspect for leaks. Turn off the water supply valve that youre dealing with.
Step 3 - Tighten Shut off Valve Water Supply Line. Place the jaws of the pliers around the packing nut on the valve and turn the valve counterclockwise until it pulls free from the supply pipe. Do not remove the valve just tighten the packing nut.
Start by disconnecting the water line from the valve. Remove the packing nut. Dont use any pipe dope or plastic tape on the valve stems threads.
Remove the screw from the handle of the valve. If you still notice a leak then you will have to investigate further by taking apart the water supply valve to clean or replace the washers. If this valve loosens water.
Avoid gumming up the inside of the shutoff valve. Disassemble the shutoff valveleaving the toilet and supply lines intact. Replace the washer and secure the valve stem and packing nut.
Then pour a small amount of oil down the valves shaft and allow it to soak for a while. Place a bucket and towels under the water supply valve. If the leak still hasnt stopped the next culprit youll want to check out are the rubber washers.
Before you check out the washers its important to cut off your water at your shut-off valve. Shut off the main water supply to the toilet. Heat the valve body with a hairdryer and see if your wrench is now effective.
This valve replenishes the supply of water to the tank after a flush. In some cases bad or damaged washers can cause a leak in your toilet supply line. There are two nuts near the fill valve.
Use a towel to mop up any spilled water. Flex the neoprene to try to get it supple again. Hopefully this is enough to compress the rubber gasket so that it is sealed on the valve stem to prevent water leaks.
If the leakage persists proceed in the following manner. Open the water main in the house then loosen the toilet shut-off valve by turning it counterclockwise. Check Out the Rubber Washers.
You need to tighten the inlet of the toilet line in the shutoff valve. As the water begins filling the toilets tank check for leaks around the new valve. The bottom of the toilet tank has a hole for the fill valve.
